Start with the question you need to resolve: substrate preparation, bonding process, validation or material selection. These guides help frame project trials; product claims and test conditions should be checked against current technical documents.
Page updated：
Created 2026-10-18 · Peel and shear testing
Understand what peel and lap-shear tests reveal by checking joint loads, specimens and result units. Use a report checklist to assess automotive interior bonds without comparing unlike conditions or treating specimen data as a guarantee for a complete part.
Read the technical article →
2026-10-01 · R-5670
R-5670 leads at 1 and 5 minutes in a three-adhesive peel comparison; FL063 leads at 8 hours. Review conditions and request samples.
Read the technical article →
2026-09-30 · R-5670
How RELANET used cross-tests, a revised skin construction and R-5670 + R-60C to resolve door-trim blistering before production release.
Read the technical article →
2026-09-27 · R-5610
Explore light scattering, polyurethane structure and film formation in transparent adhesive layers, with RELANET R-5610 process guidance.
Read the technical article →
2026-09-20 · R-5670 + R-60C
R-5670/R-60C on PVC-knit/flame-treated PP: average 25 N/25 mm at 1 min; about 60 N/25 mm after 7 days. Review the test conditions.
Read the technical article →
Understand dyne pens, contact angles and primers in automotive bonding. Evaluate RELANET 132 and 162 with actual materials and processes.
Read full article
Compare adhesive film and water-based spray adhesive for automotive interiors: total cost, ROI, shared equipment and same-batch A/B trials.
Read article
Evaluate an automotive adhesive-film platform through design freeze, investment, traceability, capacity and eight production-release gates.
Read articlePlan headliner adhesive trials with actual fabrics, foams and carriers. Assess early hold, heat creep, humidity aging and final bonding.
Plan headliner adhesive trials using actual fabrics, foams and supporting layers. Record early hold, coating sag, heat creep, humidity aging and final bond performance.
Read the guide →
Diagnose interior-wrapping blisters and debonding by timing, location and failure layer. Check materials, surface preparation and drying.
Read full article
Build a PUD process baseline. Separate machine settings from measurements, trace single-variable trials and review durability-release evidence.
Read full articleEvaluate automotive PUD through adhesion, temperature, humidity, appearance, process and odor/VOC. Verify source data for each application.
Read full articleAssess PUD wrapping by interface, springback and early holding. Define peel checkpoints and validate the process on representative parts.
Read full articleExplore RELANET automotive PUD materials and processes. Check bonding, durability, odor and VOC against the grade and actual substrates.
Read full article
Compare R-5610 films and laminates under fixed viewing conditions. Record changes and confirm performance with issued documents and real specimens.
Read full articleEmail your layer stack, material grades, production process, test targets, company name and business contact details. You can also request the current TDS, SDS or samples.
Email your project requirements →